How to mount a front license plate tacoma

How to mount a front license plate tacoma install#
How to mount a front license plate tacoma drivers#

I installed my UCA's 'Solo' So if you have an extra set of hands it might be faster. But if you take your time it is a job that should take you about 2 1/2 hours. Your battery and the wire harness bracket.( Battery terminals, and the bracket are 10mm)

How to mount a front license plate tacoma drivers#

and you are done.ДЇor the drivers side you will need to remove a few extra parts. Use a zip tie to secure the ABS hose.Д«end your inner fenders back to it original position, reinstall your sway bar, fender skirts, and wheels.

How to mount a front license plate tacoma install#

Take care to install the inserts into the ball joint before you attempt to install it. To install the Camburg you just reverse the process: Remember to apply grease to the replacement washers. Remember to use your stock bottle jack or a jack stand to support the Lower 'A' arm. (I used a Channel lock plier.) It is the clean section in the photo. You will need to bend the front portion of the inner fender, inorder to remove the 19mm main bolt of the UCA. (You will need to use a hammer to pop the compression fitting out) That is the reason you need to remove the sway bar. Remove the wire retaining clip and loosen the nut, that is located just above the sway bar, it is the nut from the UCA to the spindle upper mount. Next remove the nut for the sway bar and get it out of the way. You will not be using these clamps again. This removal is optional, but it make it easier if the bracket is out of the way. Then remove the 10mm bolt that holds the ABS hose. Next you will need to remove the push pegs that hold up the fender skirts to expose the UCA's main bolt. This will save you time rather then pump it with grease later.

Install all your bushings and fill them with grease prior to installing the steel insert. These are self tapping and fairly easy to install. Some all purpose grease and or a grease gun.ДЇirst of all you need to install the Grease nipples. (To bend the bracket that holds the ABS hose)ДЄ sizable Hammer (to punch out the tapered stock UCA spindle joint)ДЄ Torque wrench (To torque all your bolts) Wheel block (To ensure that your truck doesn't roll)ДЎ9mm (For the main UCA bolt, you will need a 19mm open end or box wrench also)ДЎ0mm ( For the brackets, and the battery terminal)ДЎ3/16'(For the bolt that mounts the spindle)Д§/8' (For the new nut that mounts the spindle)Д¬hannel lock pliers (To bend the inner fender) Your stock bottle jack (To support the lower 'A' arm)